en:x300:koppeling
This is an old revision of the document!
Park spindle in the rear left corner
+ 
The PARK Y+ function + will move the spindle assembly to the very rear of the engraving table.
Activating Park Y+.
Press the SHIFT key and then the X-Y+-AXIS ARROW to park the spindle in the rear left corner of the engraving table.
Keypad status bar displays:
“Parking …”
Return to the keypad overview.
Continue to the table of contents.
en/x300/koppeling.1664138294.txt.gz · Last modified: 2022/09/25 22:38 by erik.ketele
