===== Vacuum cleaner for dust extraction =====

{{:en:x300:vac-aux_uitgangen.jpg?600|}}\\
\\
The Cyborg X-300 should always be used with a dust extractor\\
The X-300 controller can switch a vacuum cleaner on and off automatically at the beginning and at the end of an engraving job.\\
To do so there is a dedicated 24 VDC outlet at the rear of the machine.  In fact there are 2 identical outlets.\\
The lower one is meant to connect the vacuum cleaner.\\
\\
{{:en:x300:stofzuiger-groen.jpg?60|}} If this icon is shown on the virtual pendent, the vacuum cleaner outlet will be powered.\\
{{:en:x300:stofzuiger-rood.jpg?60|}} If this icon is shown on the virtual penden, the vacuum outlet will not be powered.\\
\\
{{:en:x300:dsc_9147.png?300|}}\\
Every X-300 comes with a short cable with plug to put in the "dust collector" outlet.\\
The purpose is to switch on and off a 24 VDC relay which in turn can switch a vacuum cleaner on and off.\\
\\
Clicking on the icon will alternate between the 2 possible choices.\\


**Return to [[keypad_overview|the keypad overview]].**\\
**Continue to [[:en:x300:table_of_contents|the table of contents]].**