===== The spindle does not rotate =====

----

Check the following:\\
\\
1. Is there a timing belt between the spindle motor pulley and the spindle pulley ?\\
2. Does your virtual pendent on the computer screen show a cutter with a "green arrow" ? {{:en:x300:cutter_spinning.png?20|}}.  If it shows a red arrow {{:en:x300:cutter_nospin.png?20|}},the spindle will not rotate. \\


**Continue to [[poor_engraving_results|trouble shooting, the engraving results are poor]].**\\
**Continue to [[:en:x300:table_of_contents|the table of contents]].**