====== Move back / Move forward x times ======
\\
After having pushed one of these six keys, the spindle moves up and moves back or forth, depending upon the key pushed. Then the machine pauses till the “start” {{:en:x300:start400x400.png?50|}} key is pushed and the engraving job is resumed.
\\
| {{:en:x300:key_back1x.png?40|}} | If you push this key during an engraving job, the spindle will lift and move **back** either **one** vector or one character, depending upon the software used. |
| {{:en:x300:key_back10x.png?40|}} | If you push this key during an engraving job, the spindle will lift and move **back** either **ten** vectors or ten characters, depending upon the software used.  |
| {{:en:x300:key_back25x.png?40|}} | If you push this key during an engraving job, the spindle will lift and move **back** either **25** vectors or 25 characters, depending upon the software used.  |
| {{:en:x300:key_forward1x.png?40|}} |If you push this key during an engraving job, the spindle will lift and move **forward** either **one** vector or one character, depending upon the software used.  |
| {{:en:x300:key_forward10x.png?40|}} |If you push this key during an engraving job, the spindle will lift and move **forward** either **ten** vectors or ten characters, depending upon the software used.  |
| {{:en:x300:key_forward25x.png?40|}} |If you push this key during an engraving job, the spindle will lift and move **forward** either **25** vectors or 25 characters, depending upon the software used.  |


**Return to [[keypad_overview|the keypad overview]].**\\
**Continue to [[:en:x300:table_of_contents|the table of contents]].**