====== Spindle Test ======

{{:en:x300:key_spindletest.png?50|}}

The Spindle Test will test the controller output to the Spindle Motor. The spindle motor will stay active until the key is pressed again.

==== Activating Spindle Test ====

Press the SPINDLE TEST {{:en:x300:key_spindletest.png?30|}} key.

Keypad Display "Activating Spindle ...."

Press SPINDLE TEST {{:en:x300:key_spindletest.png?30|}} again stops the Spindle Test.

=== Note: ===

Pressing the CANCEL {{:en:x300:key_cancel.png?30|}}  key will also stop the spindle test.

\\
**Return to [[keypad_overview|the keypad overview]].**\\
**Continue to [[:en:x300:table_of_contents|the table of contents]].**