====== Decrease cut speed ======

{{:en:x300:key_feeddecrease.png?50|}}\\
This input allows you to decrease the machine’s XY travel and cut speeds to a minimum of 1%. This affects the feedrate or cut speed when the cutter is moving through the material.\\
When the machine is executing a rapid move, moving above the material, the feedrate override has no effect.

The cut speed will be displayed on the Keypad Control Panel as a percentage "%Feed" and as a real speed in “mm/s (XY)”. The feedrate override will determine the amount that the cut speed will be adjusted by.

When a file is being executed on the machine pressing the DECREASE CUT SPEED {{:en:x300:key_feeddecrease.png?30|}} hot key will decrease the feedrate in 1% increments.

Holding the DECREASE CUT SPEED {{:en:x300:key_feeddecrease.png?30|}} hot key decreases the feedrate at an increasingly faster rate.


\\
**Return to [[keypad_overview|the keypad overview]].**\\
**Continue to [[:en:x300:table_of_contents|the table of contents]].**