cyborg-engravers

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Jogging the spindle =======




| {{:en:x300:key_up.png?50|}} | **Jog to the left (X-) and to the back (Y+)**\\ Press the {{:en:x300:key_up.png?20|}} key to jog the spindle to the rear.\\ The jog speed is determined jog speed bar setting.  |
| {{:en:x300:key_left.png?50|}} | **Jog to the right (X+) and to the back (Y+)**\\ Press the {{:en:x300:key_left.png?20|}} key to jog the spindle to the left.\\ The jog speed is influenced by the jog speed bar setting.  |
| {{:en:x300:key_right.png?50|}} | **Jog to the left (X-) and to the front (Y-)**\\ Press the {{:en:x300:key_right.png?20|}} key to jog the spindle to the right.\\ The jog speed is determined by the jog speed bar setting.  |
| {{:en:x300:key_dn.png?50|}} | **Jog to the right (X+) and to the front (Y-)**\\ Press the {{:en:x300:key_dn.png?20|}} key to jog the spindle to the front.\\ The jog speed is influenced by the jog speed bar setting.  |
\\
Use the jog speed bar to change the speed {{:en:x300:snail-rabbit.jpg?200|}}. Click on the rabbit or on the turtle, or click on the dial.

\\
**Return to [[keypad_overview|the keypad overview]].**\\
**Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Page Tools