cyborg-engravers

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Increase spindle rotation speed. ======

{{:en:x300:key_rpmincrease.png?50|}}\\
\\
This input allows you to increase the RPM of the spindle to the maximum of 20000 RPM.\\
Press the SPINDLE RPM OVERRIDE {{:en:x300:key_rpmincrease.png?30|}} hot key to increase the Spindle RPM by 100 rpm increments.\\
Hold the SPINDLE RPM OVERRIDE {{:en:x300:key_rpmincrease.png?30|}} hot key to increase the Spindle RPM in 1000 rpm increments.\\
The Spindle RPM can also be increased while a file is being executed.\\
The current Spindle RPM will be displayed on the Keypad Control Panel as ####"RPM".\\

**Note:**
When the system receives a new spindle speed command (automatically while a file is being executed or manually using the hot keys), the spindle speed will be set to that value.

\\
**Return to [[keypad_overview|the keypad overview]].**\\
**Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Page Tools