cyborg-engravers

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Increase cut speed ======

{{:en:x300:key_feedincrease.png?50|}}\\
This input allows you to increase the machine’s XY travel and cut speeds to a maximum of 150%.\\
This affects the feedrate or cut speed when the cutter is moving through the material. When the machine is executing a rapid move, moving above the material,\\
the feedrate override has no effect. The cut speed will be displayed on the Keypad Control Panel as a percentage "%Feed" and as a real speed in “mm/s (XY)”.\\
The feedrate override will determine the amount that the cut speed will be adjusted by.

When a file is being executed on the machine pressing the INCREASE CUT SPEED {{:en:x300:key_feedincrease.png?30|}} hot key will increase the feedrate in 1% increments.

Holding the INCREASE CUT SPEED {{:en:x300:key_feedincrease.png?30|}} hot key increases the feedrate at an increasingly faster rate.
\\
\\
**Return to [[keypad_overview|the keypad overview]].**\\
**Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers

User Tools

Site Tools

Page Tools