Differences

This shows you the differences between two versions of the page.

--- en:x300:two_way_engraving_metals [2023/10/20 10:17]
jan.vangelder
+++ en:x300:two_way_engraving_metals [2025/04/18 15:50] (current)
erik.ketele
@@ Line 12: / Line 12: @@
 In order to automatically obtain a reverse cut at the end of every cut vector, all you have to do before running the engraving job is click the {{:en:x300:bidirectional-red-green.png?40|"Menu"}} icon on the virtual keypad, so that it becomes {{:en:x300:bidirectional-green-green.png?40|}}.
-|__**Note:**__  \\  \\ When engraving with the nosecone, the reverse option contains a potential danger. When the reverse moves happen, the nose cone might drop into an already engraved surface, causing a staircase effect. So be careful to use this two-way engarving technique only with single line or relatively small multiple line characters, or only without nosecone and a locked floating mechanism.  |
+|__**Note:**__  \\  \\ When engraving with the nosecone, the reverse option contains a potential danger. When the reverse moves happen, the nose cone might drop into an already engraved surface, causing a staircase effect. So be careful to use this two-way engraving technique only with single line or relatively small multiple line characters, or only without nosecone and a locked floating mechanism.  |
 **Continue to [[adjusting_feeds_and_speeds|adjusting feeds and speeds]].**\\

cyborg-engravers