| Both sides previous revision
Previous revision
|
|
en:x300:safety_instructions [2023/05/17 10:05]
127.0.0.1 external edit |
en:x300:safety_instructions [2026/06/24 12:02] (current)
erik.ketele |
| |{{ :en:x300:fire.png?50 |{afbeelding}}|Do not operate this machine in the neighbourhood of open fire. Engraving powder, chips, some plastics, woods and even some metals may catch fire. | | |{{ :en:x300:fire.png?50 |{afbeelding}}|Do not operate this machine in the neighbourhood of open fire. Engraving powder, chips, some plastics, woods and even some metals may catch fire. | |
| |{{ :en:x300:warning.png?50 |{afbeelding}}|To remove the dust and the engraving chips which were not removed by the vacuum boot, always use a vacuum cleaner, never use compressed air. To get rid of dust in narrow spaces, use a small soft brush, such as a toothbrush. | | |{{ :en:x300:warning.png?50 |{afbeelding}}|To remove the dust and the engraving chips which were not removed by the vacuum boot, always use a vacuum cleaner, never use compressed air. To get rid of dust in narrow spaces, use a small soft brush, such as a toothbrush. | |
| |{{ :en:x300:warning.png?50 |{afbeelding}}|Every Cyborg X-300 is equipped with a dust removal boot on the depth regulator nose assembly. Always use a vacuum cleaner to remove the engraving dust and chips. Make sure this vacuum cleaner is explosion free. | | |{{ :en:x300:warning.png?50 |{afbeelding}}|Every Cyborg X-300 is equipped with a dust removal boot on the depth regulator nose assembly. Always use a vacuum cleaner to remove the engraving dust and chips. | |
| |{{ :en:x300:verbod.png?50 |{afbeelding}}|Never try to cut or engrave flammable materials, such as magnesium. | | |{{ :en:x300:verbod.png?50 |{afbeelding}}|Never try to cut or engrave flammable materials, such as magnesium. | |
| |{{ :en:x300:warning.png?50 |{afbeelding}}|Before launching a cutting or an engraving job, always make sure your material and the cutter are securely fastened, and that no tools or accessories are lying around in the zone of the automatic machine moves. | | |{{ :en:x300:warning.png?50 |{afbeelding}}|Before launching a cutting or an engraving job, always make sure your material and the cutter are securely fastened, and that no tools or accessories are lying around in the zone of the automatic machine moves. | |
