en:x300:restarting_job_console
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:restarting_job_console [2022/09/21 22:33] erik.ketele |
en:x300:restarting_job_console [2023/10/20 10:21] (current) jan.vangelder |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Resuming or Restarting the engraving job ====== | ====== Resuming or Restarting the engraving job ====== | ||
| + | |||
| + | ---- | ||
| ===== Resuming a paused engraving job ===== | ===== Resuming a paused engraving job ===== | ||
| Line 12: | Line 14: | ||
| If you need to engrave the same job several times, you engrave it once, put a new plate on the table, and you hit the Start {{: | If you need to engrave the same job several times, you engrave it once, put a new plate on the table, and you hit the Start {{: | ||
| you can repeat this as many times as you like, the machine will repeat the last engraved job everytime. | you can repeat this as many times as you like, the machine will repeat the last engraved job everytime. | ||
| + | |||
| + | ---- | ||
| **Continue to [[keypad_overview|an overview of the virtual keypad]].**\\ | **Continue to [[keypad_overview|an overview of the virtual keypad]].**\\ | ||
| **Continue to [[: | **Continue to [[: | ||
en/x300/restarting_job_console.1663792392.txt.gz ยท Last modified: 2022/09/21 22:33 by erik.ketele
