en:x300:pause_button
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
en:x300:pause_button [2022/01/06 14:18] 127.0.0.1 external edit |
en:x300:pause_button [2023/10/20 10:19] (current) jan.vangelder |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Using the pause button ====== | ====== Using the pause button ====== | ||
| - | To pause the engraving cycle in the middle of a job, you can click the “Pause” {{:user: | + | ---- |
| + | |||
| + | To pause the engraving cycle in the middle of a job, you can click the “Pause” {{:en:x300:pause.png?50|}} button on your virtual keypad. The spindle will go up, the XY moves will stop, the spindle will stop rotating and the “resume” | ||
| When in Pause-mode, several things can be done, such as jogging the spindle to another location, so that you can take a closer look at the already engraved parts, you can change cutters or change the position of the nosecone and hence the engraving depth. | When in Pause-mode, several things can be done, such as jogging the spindle to another location, so that you can take a closer look at the already engraved parts, you can change cutters or change the position of the nosecone and hence the engraving depth. | ||
| - | Clicking the Start button will resume the engraving at the right spot, even if you did jog the spindle to another location during the pause. | + | Clicking the Resume {{: |
| + | |||
| + | ---- | ||
| + | |||
| + | **Continue to [[cancel_a_job|cancelling an engraving job]].**\\ | ||
| + | **Continue to [[: | ||
en/x300/pause_button.1641475115.txt.gz · Last modified: 2022/01/06 14:18 by 127.0.0.1
