en:x300:materials_rpm_feed
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:x300:materials_rpm_feed [2022/09/21 21:34] erik.ketele |
en:x300:materials_rpm_feed [2023/10/20 10:16] (current) jan.vangelder |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Selection of materials, rotation and feed speeds ====== | ====== Selection of materials, rotation and feed speeds ====== | ||
| + | |||
| + | ---- | ||
| For every engravable material there is an ideal feed (mm/sec) and speed (rpm) which yields an optimal engraving result. When engraving, try to respect each and every one of the following principles: | For every engravable material there is an ideal feed (mm/sec) and speed (rpm) which yields an optimal engraving result. When engraving, try to respect each and every one of the following principles: | ||
en/x300/materials_rpm_feed.1663788850.txt.gz ยท Last modified: 2022/09/21 21:34 by erik.ketele
