Differences

This shows you the differences between two versions of the page.

--- en:x300:koppeling [2022/09/25 22:43]
erik.ketele
+++ en:x300:koppeling [2023/05/17 10:05] (current)
@@ Line 6: / Line 6: @@
 **Activating Park Y+.**\\
-Press the SHIFT {{:en:x300:key_shift.png?30|}} key and then the Y+-AXIS ARROW {{:en:x300:key_up.png?30|}} to park the spindle in the rear left corner of the engraving table.\\
+Press the SHIFT {{:en:x300:key_shift.png?30|}} key and then the Y+-AXIS ARROW {{:en:x300:key_up.png?30|}} to park the spindle in the rear of the engraving table.\\
 Keypad status bar displays:\\
  "Parking ..."

cyborg-engravers