Differences

This shows you the differences between two versions of the page.

--- en:x300:koppeling [2022/09/25 22:36]
erik.ketele
+++ en:x300:koppeling [2023/05/17 10:05] (current)
@@ Line 1: / Line 1: @@
-===== Park spindle in the rear left corner=====
+===== Park spindle in the rear =====
-{{:en:x300:key_shift.png?50|}} + {{:en:x300:key_upleft.png?50|}}\\
+{{:en:x300:key_shift.png?50|}} + {{:en:x300:key_up.png?50|}}\\
-The PARK Y+ function {{:en:x300:key_shift.png?30|}} + {{:en:x300:key_upleft.png?30|}} will move the spindle assembly to the very rear of the engraving table.\\
+The PARK Y+ function {{:en:x300:key_shift.png?30|}} + {{:en:x300:key_up.png?30|}} will move the spindle assembly to the very rear of the engraving table.\\
 **Activating Park Y+.**\\

cyborg-engravers