Differences

This shows you the differences between two versions of the page.

--- en:x300:koppeling [2022/09/25 22:30]
erik.ketele
+++ en:x300:koppeling [2023/05/17 10:05] (current)
@@ Line 3: / Line 3: @@
 {{:en:x300:key_shift.png?50|}} + {{:en:x300:key_up.png?50|}}\\
-The PARK Y {{:en:x300:key_shift.png?30|}} + {{:en:x300:key_up.png?30|}} function will move the spindle assembly to the very rear of the engraving table.\\
+The PARK Y+ function {{:en:x300:key_shift.png?30|}} + {{:en:x300:key_up.png?30|}} will move the spindle assembly to the very rear of the engraving table.\\
-**Activating Park Z.**\\
+**Activating Park Y+.**\\
-Press the SHIFT {{:en:x300:key_shift.png?30|}} key and then the Z-AXIS JOG UP ARROW {{:en:x300:key_zup.png?30|}} to raise the spindle assembly to the absolute Z 0 position.\\
+Press the SHIFT {{:en:x300:key_shift.png?30|}} key and then the Y+-AXIS ARROW {{:en:x300:key_up.png?30|}} to park the spindle in the rear of the engraving table.\\
 Keypad status bar displays:\\
  "Parking ..."

cyborg-engravers