Differences

This shows you the differences between two versions of the page.

--- en:x300:koppeling [2022/09/25 10:26]
erik.ketele created
+++ en:x300:koppeling [2023/05/17 10:05] (current)
@@ Line 1: / Line 1: @@
-====== hidden function ======
+===== Park spindle in the rear =====
-\\
-This function is only accessible for servicing purposes.
+{{:en:x300:key_shift.png?50|}} + {{:en:x300:key_up.png?50|}}\\
-Only trained technicians should use this function.
+The PARK Y+ function {{:en:x300:key_shift.png?30|}} + {{:en:x300:key_up.png?30|}} will move the spindle assembly to the very rear of the engraving table.\\
+**Activating Park Y+.**\\
+Press the SHIFT {{:en:x300:key_shift.png?30|}} key and then the Y+-AXIS ARROW {{:en:x300:key_up.png?30|}} to park the spindle in the rear of the engraving table.\\
+Keypad status bar displays:\\
+ "Parking ..."
 \\
+**Return to [[keypad_overview|the keypad overview]].**\\
+**Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers