Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
Next revision
|
Previous revision
|
en:x300:jog_xy_keys [2022/09/25 22:02]
erik.ketele |
en:x300:jog_xy_keys [2023/05/17 10:05] (current)
|
| ====== Diagonal jogging keys ====== | ====== Diagonal jogging keys ====== |
| |
| | | | | | |
| | | | | | |
| | | | | | |
| |
| | {{:en:x300:key_upleft.png?50|}} | **Jog to the left (X-) and to the back (Y+)**\\ Press the {{:en:x300:key_upleft.png?20|}} key to jog the spindle to the left and to the rear simultaneously.\\ The jog speed is determined jog speed bar setting. | | |
| | {{:en:x300:key_upright.png?50|}} | **Jog to the right (X+) and to the back (Y+)**\\ Press the key to jog the spindle to the right and to the rear simultaneously.\\ The jog speed is influenced by the jog speed bar setting. | | |
| | {{:en:x300:key_downleft.png?50|}} | **Jog to the left (X-) and to the front (Y-)**\\ Press the key to jog the spindle to the left and to the front simultaneously.\\ The jog speed is determined by the jog speed bar setting. | | |
| | {{:en:x300:key_downright.png?50|}} | **Jog to the right (X+) and to the front (Y-)**\\ Press the key to jog the spindle to the right and to the frontsimultaneously.\\ The jog speed is influenced by the hot key setting. | | |
| |
| | | {{:en:x300:key_upleft.png?50|}} | **Jog to the left (X-) and to the back (Y+)**\\ Press the {{:en:x300:key_upleft.png?20|}} key to jog the spindle to the left and to the rear simultaneously.\\ The jog speed is determined jog speed bar setting. | |
| | | {{:en:x300:key_upright.png?50|}} | **Jog to the right (X+) and to the back (Y+)**\\ Press the {{:en:x300:key_upright.png?20|}} key to jog the spindle to the right and to the rear simultaneously.\\ The jog speed is influenced by the jog speed bar setting. | |
| | | {{:en:x300:key_downleft.png?50|}} | **Jog to the left (X-) and to the front (Y-)**\\ Press the {{:en:x300:key_downleft.png?20|}} key to jog the spindle to the left and to the front simultaneously.\\ The jog speed is determined by the jog speed bar setting. | |
| | | {{:en:x300:key_downright.png?50|}} | **Jog to the right (X+) and to the front (Y-)**\\ Press the {{:en:x300:key_downright.png?20|}} key to jog the spindle to the right and to the frontsimultaneously.\\ The jog speed is influenced by the hot key setting. | |
| | \\ |
| | **Return to [[keypad_overview|the keypad overview]].**\\ |
| | **Continue to [[:en:x300:table_of_contents|the table of contents]].** |
