Differences

This shows you the differences between two versions of the page.

--- en:x300:fixing_engraving_material [2022/09/18 13:38]
erik.ketele [Using the optional vacuum table]
+++ en:x300:fixing_engraving_material [2023/05/17 10:05] (current)
@@ Line 25: / Line 25: @@
 {{:en:x300:vacuum_table.jpg?nolink&250x167|ASCII}}
-The optional vacuum table can replace the standard flat engraving table.  It is supplied with spunge rubber cord to delimit the vacuum zone.  under this phenolic table there is a compressed air connection.  the vacuum hose goes from there to either a vacuum pump or a vacuum converter, both of which have to be provided by the customer (hense they are not included with the vacuum table).
+The optional vacuum table can replace the standard flat engraving table. It is supplied with spunge rubber cord to delimit the vacuum zone. under this phenolic table there is a compressed air connection. the vacuum hose goes from there to either a vacuum pump or a vacuum converter, both of which have to be provided by the customer (hense they are not included with the vacuum table).  This vacuum table uses the same 6 screws which are used for the standard engraving table.
+**Continue to [[tool_setup|setting up a tool]].**\\
 **Continue to [[:en:x300:table_of_contents|the table of contents]].**

cyborg-engravers