Differences

This shows you the differences between two versions of the page.

--- en:x300:find_machine_origin [2022/09/24 23:21]
erik.ketele
+++ en:x300:find_machine_origin [2023/05/17 10:05] (current)
@@ Line 6: / Line 6: @@
 \\
 **Finding Machine Home.**\\
-Press the SHIFT  and then the GO HOME   hot keys to index the gantry, carriage, and Z assembly off of the limit switches when:
+\\
- a) The machine has just been turned on.
+Press the SHIFT {{:en:x300:key_shift.png?20|}} and then the GO HOME {{:en:x300:key_gohome.png?20|}} hot keys to index the gantry, carriage, and Z assembly off of the limit switches when:\\
- b) The machine has stalled (lost position).
+ a) The machine has just been turned on.\\
-Keypad status line display:
+ b) The machine has stalled (lost position).\\
- "Homing Z ...", then “Homing Y…”, and then “Homing X…”
+\\
- The display will show each axis coordinate to be 0.0 when the targets are located.
+Keypad status line display:\\
+ "Homing Z ...", then “Homing Y…”, and then “Homing X…”\\
+ The display will show each axis coordinate to be 0.0 when the targets are located.\\
 \\

cyborg-engravers