en:x200:spindle_belt_replacement
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
|
|
en:x200:spindle_belt_replacement [2025/04/20 12:47]
erik.ketele |
en:x200:spindle_belt_replacement [2025/04/20 12:47] (current)
erik.ketele |
| {{:en:x300:dsc_9155.jpg?600|ASCII}} \\ \\ On the above image it is clearly visible that there is no strain on the timing belt. \\ \\ Follow the 4 steps below to take off the timing belt from the spindle. \\ \\ {{:en:x300:remove_belt.png?1200}} \\ 1. Spindle with cutter and cutter knob \\ 2. spindle with cutter and cuuter knob removed \\ 3. Rotate spindle clockwise and simultaneously move the belt up on the spindle pulley \\ 4. Finally the timing belt will come off the spindle pulley. \\ \\ When putting on a new belt, first put it around the spindle motor pulley, then rotate it clockwise over the spindle pulley. | {{:en:x300:dsc_9155.jpg?600|ASCII}} \\ \\ On the above image it is clearly visible that there is no strain on the timing belt. \\ \\ Follow the 4 steps below to take off the timing belt from the spindle. \\ \\ {{:en:x300:remove_belt.png?1200}} \\ 1. Spindle with cutter and cutter knob \\ 2. spindle with cutter and cuuter knob removed \\ 3. Rotate spindle clockwise and simultaneously move the belt up on the spindle pulley \\ 4. Finally the timing belt will come off the spindle pulley. \\ \\ When putting on a new belt, first put it around the spindle motor pulley, then rotate it clockwise over the spindle pulley. |
| |
| **Continue to [[:en:x200:timing_belt_tensioning|greasing the leadscrews]].** \\ | **Continue to [[:en:x200:greasing_the_leadscrews|greasing the leadscrews]].** \\ |
| **Continue to [[:en:x200:table_of_contents|the table of contents]].** | **Continue to [[:en:x200:table_of_contents|the table of contents]].** |
| |
| |
en/x200/spindle_belt_replacement.txt ยท Last modified: 2025/04/20 12:47 by erik.ketele
