en:x200:materials_rpm_feed
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
en:x200:materials_rpm_feed [2025/04/18 15:43] erik.ketele |
en:x200:materials_rpm_feed [2025/04/18 15:46] (current) erik.ketele |
||
|---|---|---|---|
| Line 11: | Line 11: | ||
| - When engraving metals, especially if you do not use the nosecone, it is very important that the entire plate is fixed vibration-free to the engraving table. | - When engraving metals, especially if you do not use the nosecone, it is very important that the entire plate is fixed vibration-free to the engraving table. | ||
| - | | **Note:**\\ \\ Always be careful at what you try to achieve. The tougher the material, the more careful you have to be. For example, engraving stainless steel is possible if you do not try to achieve excessive results. The Cyborg X-300 is a relatively lightweight engraver, which is not the same as a router. You can engrave stainless steel with a relatively small cutter tip (e.g. 0.5 to 1.0 mm) at moderate depths (e.g. 0.05 to 0.15 mm). You cannot engrave stainless steel with a 3 mm wide cutter tip at a depth of 0.5 mm or more. What you can and what you cannot do is very difficult to say, it depends upon many variables, under which the grade of stainless, the quality of the cutter, the cutting strategy, etc. | | + | | **Note:**\\ \\ Always be careful at what you try to achieve. The tougher the material, the more careful you have to be. For example, engraving stainless steel is possible if you do not try to achieve excessive results. The Cyborg X-200 is a relatively lightweight engraver, which is not the same as a router. You can engrave stainless steel with a relatively small cutter tip (e.g. 0.5 to 1.0 mm) at moderate depths (e.g. 0.05 to 0.15 mm). You cannot engrave stainless steel with a 3 mm wide cutter tip at a depth of 0.5 mm or more. What you can and what you cannot do is very difficult to say, it depends upon many variables, under which the grade of stainless, the quality of the cutter, the cutting strategy, etc. | |
| ==== Rotary engraving ==== | ==== Rotary engraving ==== | ||
| - | The following materials can be rotary-engraved with the Cyborg X-300: | + | The following materials can be rotary-engraved with the Cyborg X-200: |
| * All different kinds of ABS- and PMMA-based multilayer engraving materials, e.g. Graflux | * All different kinds of ABS- and PMMA-based multilayer engraving materials, e.g. Graflux | ||
| Line 34: | Line 34: | ||
| * Stainless steel | * Stainless steel | ||
| - | * Pre-etched or anodized machine or motor tags | + | * Pre-etched or anodized |
| * Glass | * Glass | ||
| **Continue to [[two_way_engraving_metals|bidirectional engraving]].**\\ | **Continue to [[two_way_engraving_metals|bidirectional engraving]].**\\ | ||
| **Continue to [[: | **Continue to [[: | ||
en/x200/materials_rpm_feed.txt ยท Last modified: 2025/04/18 15:46 by erik.ketele
